As a more advanced packaging method on the market at present, heat shrink packaging machine has become the heart of many packaging companies with its own advantages, widely used in the packaging of various small products, and the advantages of environmental protection and economy shown in the use process are more for its color. In the face of modern automatic heat shrink packaging machine to find their own position in the market, in many industries have a full heat shrink packaging machine figure, it is more means the development of enterprises, so in the development, only by constantly accelerating their own development speed, can we better achieve the rapid development of enterprises
Daily maintenance of heat shrink machine.
　　1, the packaging machine temperature is -10℃ ~ 50℃, relative humidity 85? Under, the surrounding air has corrosive gases, dust, and explosion danger.
　　2, often check whether the parts of the packaging machine are in good condition, such as the vacuum pump of the vacuum packaging machine is working normally, and the vacuum pump motor is not reversed.
　　3. The position of the 3D transparent film packaging machine should be checked frequently. Normal oil level is 1/2-3/4 of the oil window (do not exceed). Vacuum pump oil color turns black. That's when you need a new oil. Usually, it is replaced every 1 to 2 months of continuous work.
　　4, the impurity filter needs to be removed and cleaned frequently (generally 1-2 months to clean once, such as packaging debris, will reduce the cleaning time).
　　5, after 2-3 months of continuous work, it is necessary to open the back cover 30, lubricate the sliding parts and switch convex points, and lubricate the connection operation of the heating rod, depending on the use.
　　6, the heating strip and silicone strip should be kept clean, no foreign matter, so as not to affect the sealing quality.
　　7, on the heating rod, the second layer of adhesive under the heating film plays the role of heat insulation material. If it is damaged, it should be replaced in time to avoid short circuit.
　　8, the user to prepare the working air source and expansion air source. The working pressure of the vacuum packaging machine is set to 0.3MPa. Don't adjust too much unless there are special circumstances.
　　9, the packaging machine must have a reliable grounding device during installation, and must not tilt or impact during transportation, but must not put down for transportation.
　　10, work before the power ventilation. To shut down, turn off the power first, then turn off the power. In case of emergency, turn off the power immediately.